| | After
powering up, the controller displays "BAD PARAMETERS". This message
indicates a recipe checksum error has occurred.
The following procedure
Erases all Recipes.
(This procedure can be performed with the controller
connected or disconected to the SRD).
- This
procedure can be performed with the controller connected to the SRD or on a bench.
- Remove
controller lid and lift the power supply tray
- Turn
on controller power switch.
- Depress
both Memory Clear Buttons.
(SW1 and SW2 buttons located on
the main logic board, see photo below). - Release
SW1 first (SW1 switch located on left), then release SW2
(located in the middle).
-
If the error does not clear, contact Rhetech
Customer Service
|
