Spin Rinser Dryer FAQs

FAQ Index

These FAQs are intended for use by trained personnel only. Before performing this or anywork on your equipment, users should consult the relevant equipment manual and take all normal and recommended safety precautions. Improper servicing of this equipment could void any applicable warranty.

Don't see your question here? Contact Rhetech for technical support

1	Q. What do the P228/P328 numeric controller codes mean? A. DISPLAY & ERROR CODES FOR P228 &P328/I CONTROLLERS
2	Q. How do I clear a "Bad Parameters" prompt on 101 controller? A. 101 CONTROLLER SHOWS "BAD PARAMETERS" / RESETTING CONTROLLER Q. How do I clear a "CPU Fail 3" prompt on 102 controller? A. 102 CONTROLLER SHOWS "CPU Fail 3" / RESETTING CONTROLLER
3	Q. What causes excessive SRD vibration? A. Is my rotor out of balance? A. What RPM is the rotor being spun at?
4	Q. What is the best N2 facilty setting for good SRD particle performance? A. 25-28 PSI dynamic is a good basic setting for particle performance.
5	Q. What causes residue on the shaft of my QD (quick detach) rotor? A. The most significant cause is the age and condition of the seals.
6	Q. How do I lock in my recipe settings on a 101 controller? A. Two Dip switches lock out the Diagnostics and Recipe on the 101 controller.
7	Q. When operating an SRD at 1200 rpm during the rinse cycle we can't get above 5.0 m ohms resistivity. Dropping the speed to 300 rpm causes the resistivity to go up to 16.5. What causes this? A. Run the rinse RPM within the limits set in the manual (300-600 RPM).
8	Q. How do I set up an FN-10, or FW-10R ? A. FN-10/ FW-10R set up procedure

Next...

Still have questions? Contact Rhetech Customer Service