Troubleshooting FAQs

	Q. What causes excessive SRD vibration? A. Is my rotor out of balance? A. What RPM is the rotor being spun at?
	Q. When operating an SRD at 1200 rpm during the rinse cycle we can't get above 5.0 m ohms resistivity. Dropping the speed to 300 rpm causes the resistivity to go up to 16.5. What causes this? A. Run the rinse RPM within the limits set in the manual (300-600 RPM).
	Q. Our heater blanket adhesive has come loose. What type of glue can we use? A. If the heater blanket adhesive should come loose we recommend...
	Q. How do I test the CY-20 emitter points to see if they are operating properly ? A. The CY-20 is a direct current static control system with the ionizing needles/pins...
	Q. We are having a particle problem that we are attributing to bacteria in our DI system. Do you have a recommended cleansing process to reduce or eliminate organics/bacteria in a DI facility feed? A. Hydrogen Peroxide Flush
	Q: I am experiencing a “Dry Probe” error on my PSC-107 / PSC-108 equipped SRD A: Under certain conditions…